Achieving more than the 10Amp limitation on a PLINK Injector : Technical Support

Achieving more than the 10Amp limitation on a PLINK Injector Print

Modified on: Sun, 11 Dec, 2022 at 4:52 PM

PLink Injectors are not rated for more than ten amps throughput. However, if your installation requires more than 10 Amps, we recommend following the wiring diagram below to bypass the PLink injector and power your pixels. The PLink Injector will be “back-powered” from the GND and VCC ports.

Note: Always ensure you appropriately fuse your installation and pay attention to the maximum current rating of your pixel strip or dots.

Did you find it helpful? Yes No

Achieving more than the 10Amp limitation on a PLINK Injector Print

Related Articles