Pixel Strips & Dots

Can I adjust the PWM rate of Pixel IC's?
The short answer is no. The PWM (Pulse Width Modulation) refresh rate for all pixel ICs is part of the chip’s design and, therefore, cannot be altered (...
Fri, 8 Apr, 2022 at 10:35 AM
Getting Started with ENTTEC Pixel Strip
JST SM Connectors All ENTTEC pixel strip comes with pre-soldered JST SM connectors. These connectors are intended for quickly testing reels or short sectio...
Fri, 8 Apr, 2022 at 10:36 AM
Power Up & Down Procedure
Power Up It is advised to send control levels of 0 intensity to all pixels prior to powering up. Powering up with pixels already receiving data will cause ...
Fri, 8 Apr, 2022 at 10:37 AM
Specifying Pixels for a Project
What are Pixel LEDs? Traditional LEDs (Light Emitting Diodes) accept power and output light. Typically, these are packaged in groups of three coloured LED ...
Fri, 8 Apr, 2022 at 10:39 AM
Troubleshooting Pixel Installations
Flicker/Erratic behaviour Voltage Drop: When there is not enough power running through the pixels to adequately power them. As the voltage travels down th...
Tue, 3 May, 2022 at 7:49 AM
Pixel Project Considerations
TABLE OF CONTENTS Power  Power Supply Fuses: Voltage Drop Reinject power Cabling Cable Thickness Cable Length Maximum recommended distance betwe...
Tue, 3 May, 2022 at 6:48 AM