Common Issues in Overdrive Mode


When using Overdrive Mode, users may encounter the following issues:

  1. Reduced Framerate: As the universe count per output increases, the achievable framerate decreases. This can result in visible tearing or stuttering in fast-paced lighting sequences, especially with complex patterns or rapid color changes.

  2. Synchronization Challenges: Higher universe counts at lower framerates can impact the overall synchronization of your lighting installation. This can be particularly noticeable when using the Pixelator range with ArtSync (Artnet). For optimal performance, aim to maintain a frame rate above 35 fps per universe.

Best Practices for Using Overdrive Mode

  • Monitor Framerate Requirements: Use the minimum number of universes per output to maintain a higher framerate if your installation demands fast refresh rates.
  • Test with Your Fixtures: Test Overdrive Mode settings with your specific fixtures to ensure acceptable performance.

Troubleshooting Tips

  • If you experience visible tearing or delayed response times, reduce the universe count per output or disable Overdrive Mode.
  • For installations requiring precise synchronization, consider using a higher framerate output configuration or consult ENTTEC support for assistance with complex setups.

For further assistance or additional support resources, please refer to the documentation available on our website or contact ENTTEC support.