Skip to main content

Working with PLink data CVC4

Updated Apr 23, 2026
5 Views
50% found this helpful

It's important that the PLink output is set on your Pixelator device to give a direct 1:1 conversion from your ArtNet or sACN source. ENTTEC recommend the following settings:

  • RGB / RGBW colour order
  • WS2812b protocol
  • No grouping


This will allow you to patch your CVC4’s within your lighting console corresponding to the CVC4’s operating mode.


If you set the colour order to anything other than RGB or RGBW the Pixelator will internally shift the channels from RGB which could lead to an incorrect colour control on your CVC4’s.

Was this article helpful?

Let us know if this article helped answer your question.

You can only submit feedback once per article.

Thank you for your feedback!

Your input helps us improve our knowledge base.

Back to CVC4 (73926)