Pixel Controllers
13 articles in this folder
ArtSync with SPI controllers
The ENTTEC Octo and Pixelator range are powerful devices designed to manage high-performance LED installations. These d...
Common Issues in Overdrive Mode
Common Issues in Overdrive Mode When using Overdrive Mode, users may encounter the following issues: Reduced Fra...
Configuring LED Tape With Octo & ELM
Your LED strips, Octo, ELM software, and wiring installation are all set. However, when you power it up, the LED strips...
ELM 2024 vs ELM 2025 Licensing - Key facts
ELM 2024 is the version supplied with some products ELM 2025 is only available as a fully paid version If you purcha...
Pixel Controller: Cabling
Maximum Cable Length: 3m 3 meters between the pixel controller and the first pixel 3 meters between each pixel A...
Pixel Controller: Pixel Grouping
Pixels can be grouped together for the purpose of reducing the number of input channels required to control a certain n...
Pixel Controller: Power Up & Down Procedure
Power Up It is advised to send control levels of 0 intensity to all pixels prior to powering up. Powering up with pixe...
Pixel Controller: Resetting to Factory Default
Factory resetting your Pixel Controller will result in the following: Resets the device name. Enables DHCP. Static...
Pixel Controllers: Merge Input Universes
There is no merge functionality implemented within ENTTEC's Pixel Controllers. This means that if you send two differen...
Pixelator Mini (70067)
The PIXELATOR MINI serves as the main hub in the PLINK control system. It can convert up to 16 Universes (32U in overdr...
Pixelator Mini Mk2 Grouping Bug
For Firmware V1.1 When grouping pixels, ensure the mapped pixels reflect the total number of pixels on the strip yo...
Resetting DIN Pixie Rev B
This is the process on how to reset DIN Pixie Rev B. This does not apply to Rev A. The Documents are attached below and...
WS2814 Custom Protocol
WS2814 Custom Protocol for OCTO/DIN PIXIE/PIXELATOR MINI Mk2 The OCTO, DIN PIXIE, and PIXELATOR MINI Mk2 allow you...